Susanne
This action may take several minutes for large corpora, please wait.
doc#118 higher temperature than the rest of the anode surface changed size and location continuously.
doc#118 arc voltage was measured. To measure the surface temperature of the anode plug, the surface
doc#118 surface temperature of the anode plug, the surface was scanned with a pyrometer. As it turned
doc#118 region was estimated by eye. The rest of the surface had a temperature which decreased towards
doc#118 by <formul>. The mean temperature of the surface was then computed according to the following
doc#118 Assuming thermal equilibrium between the anode surface and the transpiring argon, the gas enthalpy
doc#118 listed in Table 1 together with the measured surface temperatures and arc voltages. Simultaneously
doc#118 voltages. Simultaneously with the anode surface temperature and voltage measurements pyrometer
doc#118 readings were taken along the cylindrical surface of the carbon anode holder as indicated
doc#118 indicated an equilibrium temperature of the surface of <formul>. This temperature was taken
doc#118 is sufficiently small compared with the surface temperature of the anode holder, to make
doc#118 Ref. 7. The radiation loss from the anode surface was computed according to <formul> where
doc#119 curvature if we assume: (<bital>A<eital>) The surface tension is uniform on the surface of the
doc#119 (<bital>A<eital>) The surface tension is uniform on the surface of the drop. (<bital>B<eital>) That because
doc#119 of shear. Just as the pressure exerted by surface tension in a spherical drop is <formul>
doc#119 is <formul> and the pressure exerted by surface tension on a cylindrical shape is <formul>
doc#119 <formul>, the pressure exerted by any curved surface is <formul>, where <ggr> is the interfacial
doc#121 high builder<sol>active ratio. </p><p> Hard- surface cleaning in household application is represented
doc#121 builders. In addition, many of the hard- surface cleaners used for walls and woodwork had
doc#121 now also contain phosphates. These hard- surface cleaners are discussed in Chapter 28. THE