This action may take several minutes for large corpora, please wait.
doc#118 | measuring the characteristic anode surface | temperature | (see below) since only a small region of |
doc#118 | simultaneous measurement of the anode surface | temperature | and the temperature distribution along |
doc#118 | voltages. Simultaneously with the anode surface | temperature | and voltage measurements pyrometer readings |
doc#118 | voltage was measured. To measure the surface | temperature | of the anode plug, the surface was scanned |
doc#118 | sufficiently small compared with the surface | temperature | of the anode holder, to make the energy |
doc#118 | energy transfer depends on the current, the | temperature | in the arc column, the anode material, |
doc#111 | have ample light when the sun sets; the | temperature | of our homes is independent of the seasons |
doc#126 | full swing, for instance, in August. The | temperature | then is still very high. At the old nest |
doc#120 | similar to that of Andrew and Eades. The | temperature | was maintained to within about <formul> |
doc#118 | all blowing rates, assuming <formul>. The | temperature | dependent value of <egr> was taken from |
doc#118 | of the anode surface temperature and the | temperature | distribution along the anode holder. Three |
doc#117 | the narrow antenna beam and because the | temperature | distribution over the central portion of |
doc#118 | temperature of this region was approximated by the | temperature | measured halfways between the edge of the |
doc#118 | in figure 4 was taken as typical for the | temperature | distribution for all blowing rates. </p> |
doc#118 | the plug holder is thereby <formul> The | temperature | distribution of figure 4 gives <formul> |
doc#118 | metal parts. It was calculated from the | temperature | gradient <formul> at <formul> inch as <formul> |
doc#122 | manifold fillings were illuminated in the | temperature | range from 40 to 85° in a further endeavor |
doc#117 | apparent black-body disk temperature is the | temperature | which must be assumed for the black body |
doc#118 | the anode were determined by measuring the | temperature | rise of the coolant. To reduce heat transfer |
doc#120 | shift. </p><p> Spectra were obtained over the | temperature | range of 77-294°K. For the low-temperature |