Susanne
This action may take several minutes for large corpora, please wait.
doc#117 across the moon to the average brightness temperature of the moon over the antenna beam (assuming
doc#117 antenna beam (assuming that the brightness temperature of the sky is negligible) was found, by
doc#118 plug. It was denoted by <formul>. The mean temperature of the surface was then computed according
doc#118 shown in figure 2 indicated an equilibrium temperature of the surface of <formul>. This temperature
doc#118 thermocouple was used to measure the upstream temperature of the transpiring gas. It was exposed
doc#118 the outer diameter of the plug. The mean temperature of this region was approximated by the
doc#125 buffer, pH 8.6, ionic strength 0.075, at room temperature on Whatman 3MM filter paper. Five milliamperes
doc#119 internal energy of an ideal gas depends on temperature only and is independent of pressure or
doc#122 manifold fillings were illuminated in the temperature range from 40 to 85° in a further endeavor
doc#120 shift. </p><p> Spectra were obtained over the temperature range of 77-294°K. For the low-temperature
doc#118 available for industrial use or as high temperature research tools often more than 50% of the
doc#118 the anode were determined by measuring the temperature rise of the coolant. To reduce heat transfer
doc#118 the arc. This region which had a higher temperature than the rest of the anode surface changed
doc#126 full swing, for instance, in August. The temperature then is still very high. At the old nest
doc#118 This temperature was taken as environmental temperature to which the anode holder was exposed as
doc#117 length, it should be possible to sample the temperature variation at different depths beneath the
doc#117 some depth beneath the surface, where the temperature variation due to solar radiation is reduced
doc#118 very hot region occurred on the plug. Its temperature was denoted by <formul>. The size of this
doc#122 chlorine with tagged aluminum chloride at room temperature was found to be the most satisfactory.
doc#125 saline. During the latter procedure the temperature was maintained at 2°C by surrounding the