Susanne
This action may take several minutes for large corpora, please wait.
doc#117 emission originates at some depth beneath the surface , where the temperature variation due to
doc#117 variation at different depths beneath the surface and possibly detect changes in the structure
doc#119 curvature if we assume: (<bital>A<eital>) The surface tension is uniform on the surface of the
doc#121 soiled surface by sticky substances or by the surface tension of liquids, including liquid greases
doc#101 different reality behind the facade? Does the surface hide a quite different picture? </p><p> The
doc#121 negatively charged dirt particles then leave the surface and go into the aqueous phase. This hypothesis
doc#118 arc voltage was measured. To measure the surface temperature of the anode plug, the surface
doc#118 radiation. Temperatures of the shield and of the surface of the water-cooled anode holder were measured
doc#117 thermal and electrical characteristics of the surface and subsurface materials of the moon. </p>
doc#117 the very low thermal conductivity of the surface layer which was derived from the variation
doc#118 region was estimated by eye. The rest of the surface had a temperature which decreased towards
doc#118 by <formul>. The mean temperature of the surface was then computed according to the following
doc#118 indicated an equilibrium temperature of the surface of <formul>. This temperature was taken
doc#121 permanently or temporarily sorbed on the surface in place of the soil will tend to accelerate
doc#121 polyphosphate ions would be strongly sorbed on the surface of the dirt (especially clay soils) so
doc#119 (<bital>A<eital>) The surface tension is uniform on the surface of the drop. (<bital>B<eital>) That because
doc#118 arc, a carbon shield was attached tothe surface providing an air gap of <fra116> inch between
doc#126 terrain where the water remains close to the surface and where the air is dry, so that a high
doc#117 materials which are likely to make up the surface of the moon would be partially transparent
doc#121 the dirty ones. As is the case with the surface -active agent, the requirements for builders