This action may take several minutes for large corpora, please wait.
doc#117 | emission originates at some depth beneath the | surface | , where the temperature variation due to |
doc#117 | variation at different depths beneath the | surface | and possibly detect changes in the structure |
doc#119 | curvature if we assume: (<bital>A<eital>) The | surface | tension is uniform on the surface of the |
doc#121 | soiled surface by sticky substances or by the | surface | tension of liquids, including liquid greases |
doc#101 | different reality behind the facade? Does the | surface | hide a quite different picture? </p><p> The |
doc#121 | negatively charged dirt particles then leave the | surface | and go into the aqueous phase. This hypothesis |
doc#118 | arc voltage was measured. To measure the | surface | temperature of the anode plug, the surface |
doc#118 | radiation. Temperatures of the shield and of the | surface | of the water-cooled anode holder were measured |
doc#117 | thermal and electrical characteristics of the | surface | and subsurface materials of the moon. </p> |
doc#117 | the very low thermal conductivity of the | surface | layer which was derived from the variation |
doc#118 | region was estimated by eye. The rest of the | surface | had a temperature which decreased towards |
doc#118 | by <formul>. The mean temperature of the | surface | was then computed according to the following |
doc#118 | indicated an equilibrium temperature of the | surface | of <formul>. This temperature was taken |
doc#121 | permanently or temporarily sorbed on the | surface | in place of the soil will tend to accelerate |
doc#121 | polyphosphate ions would be strongly sorbed on the | surface | of the dirt (especially clay soils) so |
doc#119 | (<bital>A<eital>) The surface tension is uniform on the | surface | of the drop. (<bital>B<eital>) That because |
doc#118 | arc, a carbon shield was attached tothe | surface | providing an air gap of <fra116> inch between |
doc#126 | terrain where the water remains close to the | surface | and where the air is dry, so that a high |
doc#117 | materials which are likely to make up the | surface | of the moon would be partially transparent |
doc#121 | the dirty ones. As is the case with the | surface | -active agent, the requirements for builders |